Installation Guides

Installation Guides – Pull Handles

Click here to find the installation guide for the Pull Handles Range

Bolt Through

  1. Use M8x60mm bolts for doors up to 44mm thick, M8x70mm for doors between 44 and 54mm thick
  2. Measure the fixing centres on the pull handle
  3. Drill 8.2-8.5ml diameter holes in the door at these centres
  4. Hold the handle against the holes, then screw the bolt into the door from the other side, loosely
  5. Tighten up all of the bolts

 

Back to Back

  1. Measure the fixing centres on the pull handle
  2. Drill 8.2-8.5ml diameter holes in the door at these centres
  3. Fix the threaded pull handle through the door with the bolts provided.
  4. When installing 19mm diameter pull handles, you will need to fit the metal washers provided under the bolt heads to prevent them pulling through the door.
  5. Once the bolt is through you can then screw on the first pull handle, and tighten fully, the bolt head should protrude through the other side of the door
  6. Slide on the opposite pull handle tight up to the metal washers
  7. Tighten the grub screws, with the hex key provided
  8. Check both handles are secure and that there’s no movement