FST Lever Handles
>Instructions
1.Ensure that the 8mm spindle and bolt through fixings are long enough to work with your door. If the door is thicker than 44mm, you may need longer fixings and spindle.
2.Insert the spindle into one of the lever handles. Ensure that the off-centre hole in the spindle faces towards the grub screw.
3.Lightly tighten the grub screw so that the spindle is held in place but without piercing through the spindle wall.
4.Insert the spindle through the lock/latch follower and locate the other handle on the spindle where it protrudes through the door. Ensure the spindle is positioned so that there is enough protruding for the other grub screw to get a purchase on it.
5.Insert the bolt through fixings into the 2 horizontal holes in the rose. Tighten these up, checking that they are well aligned and the handle still turns freely.
6.Add the fixing screws to the 2 vertical holes in the rose. Re-check that the bolt through fixings are tight.
7.Snap on the rose cover plates.
8.Finally, tighten up the grub screws with an Allen key (not a powered driver) until they have broken through the spindle wall and are tight.